Anybody else had any issues with the slip? Mine was so damn tight and took me an age to get off. When I did finally get it off, the paint had been taken off down the side
Anybody else had any issues with the slip? Mine was so damn tight and took me an age to get off. When I did finally get it off, the paint had been taken off down the side
I've found the best way to remove them and not damage anything, is to get 2 sheets of A4, fold them length ways and then width ways (so you get long and thin, then thin and half the length), then slip one down the front and one down the back of the slip, looping them around it. Put it on a desk or another surface that won't damage anything, but will also give some rigidity and support, then push the steel whilst holding the 2 tabs.